Compact, low insertion-loss, sharp-rejection, and wide-band microstrip bandpass filtersMicrowave Theory and Techniques, IEEE Transactions on, Vol. 51, No. 4. (2003), pp. 1241-1246.
|
Reviews
[Write a review of this article]
There are no reviews of this article
Find related articles from these CiteULike users
Find related articles with these CiteULike tags
AbstractThis paper presents a new compact, low insertion-loss, sharp-rejection, and wide-band microstrip bandpass filter. A bandstop filter is introduced that uses a ring resonator with direct-connected orthogonal feed lines. A new bandpass filter based on the bandstop filter uses two tuning stubs to construct a wide-band passband with two sharp stopbands. Without coupling gaps between feed lines and rings, there are no mismatch and radiation losses between them and, therefore, the new filters show low insertion loss. In addition, a dual-mode characteristic is used to increase the stopband bandwidth of the new filters. A simple transmission-line model used to calculate the frequency responses of the filters shows good agreement with measurements. The filter using three cascaded rings has 3-dB fractional bandwidth of 49.3%, an insertion loss of better than 1.6 dB in the passband, a return loss of larger than 13 dB from 4.58 to 7.3 GHz, and two rejections of greater than 40 dB within 2.75-4.02 and 7.73-9.08 GHz. The high-performance, compact-size, and low-cost filter was designed for reducing the interference in full duplex systems in satellite communications.
BibTeX record
RIS record